The perfect "pre-worboys" accessory for road junctions on layouts set in the 1950's and early 60's! This easy to build bollard kit, comes with 4 pre-assembled, 3d printed, white bollard bodies, with Micro LEDs already installed and soldered 20cm of wire. Just cut out the enclosed self-adhesive decals and fit them on to the bollard body following the enclosed instructions. Installation is quick and simple. Drilling a 1.5mm hole in your pavement & baseboard, thread the wires through, then connect them to a 12v DC supply and you're all set. Kit takes just minutes to assemble and install. Supplied in a pack of 4.